Instrumentation - CO, O2 AND NOx
John Zink Company is meeting emission-regulation challenges with a new generation of emission control. From the moment a test
is initiated, data is electronically recorded using Zink's state-of-the-art monitoring
and control capabilities.
Our test furnaces are equipped with access ports to conduct extractive sampling
for gas composition analysis across the height or length of the
furnace. Zink also uses the latest in continuous emission monitors
(CEMs) to measure flue-gas emissions. Stack samples are continuously
extracted at a high flow rate to minimize response time. A continuous
slipstream goes to the sample conditioner to chill the sample below
its dew point. Once the moisture is extracted, the CEMs measure
NOx, CO and O2.
Our research and development furnaces, which contain considerably more data-gathering probes and thermocouples, provide extensive information on the aspects of combustion and emissions.
Contact a Zink® representative for additional information.
John Zink Company, LLC
11920 East Apache
Tulsa, OK 74116
United States of America
+1-918-234-1800
email: info@johnzink.com
|
